SP11 - Ochre

SP11 - Ochre

Fires to CONE 04 - 6

A glossy deep brown flux-y glaze with tan mottled surface. Breaks into a transparent chocolate brown and floats beautifully over other glazes. On it's own you can see some amazing green and blues being pulled out from under the darker surface.

Note: this is a very fluid glaze and will run if applied too thickly. Leave at least a 1/2" space at the bottom of pieces for potential running. Use moderation for best results!

___________

Mid-range glazes, such as this, should be used on mid-range clay (meant to be fired to cone 4 - 6).

To apply: Always mix first before each use! Then brush or dip onto bisque-fired pottery (pottery that has been fired to cone 08 - 06).
If brushing, apply three layers, alternating the direction of the brush strokes with each layer to create a smooth finish. Let dry completely between each coat (until it completely loses its sheen), but do not over-dry or the glaze may crawl.

If dipping, dip and hold in the glaze, then remove from the glaze and shake off the excess. The amount of time you hold the piece in the glaze will dictate the thickness of the coat. We recommend 1 dip. A second layer can be applied, but more layers can result in the glaze running off the pot. Let dry until it loses its sheen between each coat if you are adding additional coats.

If the consistency seems thick, first mix thoroughly. If it still seems thick, add water SPARINGLY to thin it down. If too thin, leave the container open to let some of the moisture evaporate.

Note that mixing glazes together or applying one on top of the other may cause the glazes to react differently than you expect. We recommend that you always test a new glaze combination and clay/glaze combination to see how it performs.

For a more in-depth how-to, check out Pottery Glazing Techniques.